Wheelbase`s (Length)
looking for length of wheel base from centre of front wheel axel to centre rear one
from it`s shortest to it`s longest yoke SD 260mm-268mm evo4 tamiya 256mm-264mm Xray T1r 251mm-260mm xray EVO 4 251mm-260mm hot bodies, pro 4 , yoke BD , T2 ,05 ,JRXS ,415 i`m after |
Tamiya 415MSX
253mm-261mm What you need this info for??? Just curious :) |
since my race mates (not many left now :rolleyes: ) have been banging heads about certain cars go better indoors then out & vice a versa
just got me thinking in my spare time & the fact the yoke SD on it`s shortest setting is only the middle setting on the cyclone, T2 is also short we were using droop,oils,shock angles, roll bars ,roll centre we were just going around in circles then wheel base pop into my mind into why the belt cars were canning the shaft cars indoors cyclone very short also would like `our` East conversion car to go lot better indoors |
Xray T2 255mm -260mm
|
We are running the Tamiya 258mm inndoors and 257mm outdoors, so not much difference actually.....
|
Originally Posted by Eirik
We are running the Tamiya 258mm inndoors and 257mm outdoors, so not much difference actually.....
It is when the Yokomo SD is about 265mm :eek: , I think that is what 'Mr Jolly' is running from his reading his post. |
HPI Pro4 and HB Cyclone wheelbase are the same. 256mm-259mm
:nod: :tire: |
Why you not after the TC4 I feel left out :(
|
the SD was around 265mm
the other night went down to 261mm 3+1 on front 2+2 on back then the other night went 4+0 front ,1+3 rear tons better just rotated that much faster & safer when you see the cyclone wheelbase & see how quick it goes on carpet with rubbers , not suprised now with the short wheel base it uses be intresting for the BD not that good indoors but outdoors it fly`s (this is for general racers at club ,not the one off fancy pant`s driver that can make anything go fast) |
Originally Posted by i.a.s
Why you not after the TC4 I feel left out :(
didn`t think any one is using them |
I cant find a ruler. :rolleyes:
|
Originally Posted by i.a.s
I cant find a ruler. :rolleyes:
|
BRCA rules state a minimum wheelbase of 250mm and a maximum of 270.
Should be pretty simple for AEAST to lay up a short wheelbase SD chassis combined with a custom short propshaft if you want to create an indoor killer. Perhaps combined with a "short" shell like the Protoform Xsara. |
shortest the SD will go is 260mm
so with the 415,cyclones ,T2 running around 257mm no wonder they are faster on our tight tracks indoor or out |
Guess you have some dremmeling to do then :sneaky:
|
All times are GMT -7. It is currently 03:39 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.