Peak Dynasty V2 19T
#1
Peak Dynasty V2 19T
Hi, I have a problem with a V2 19T Spec.
I kind of hit the wall and it stopped working, I changed the endbell and it worked again, wierd thing is the LED in the endbell was working ok.
Anyone have any ideas what has happened?
PS The hit blew up my ESC (Cyclone too), expensive mistake.
Cheers
I kind of hit the wall and it stopped working, I changed the endbell and it worked again, wierd thing is the LED in the endbell was working ok.
Anyone have any ideas what has happened?
PS The hit blew up my ESC (Cyclone too), expensive mistake.
Cheers
#2
Tech Addict
iTrader: (4)
My guess is this, if you smacked the wall fiom the side, you probably bent the brush tubes so the brushes are hung up and popped out the bearing. If you get a steel rod that is the same diameter as the inside of the brush tube you can probably straighten them out so it will work again.