cleblanc

iTrader: (49)

what 64 pitch spur works?

trdsupra88

iTrader: (25)

I had a FDR of 8.15 on the smalll track I run on with my tc4, would it be wise to try to acheive the same ratio with the tc5?

mr crum

iTrader: (5)

u must b runnin mod mot for a fdr that low but to answer ur question it will b easier to get that fdr with tc5 cause internal drive is 2.0 compared to the tc4 is 2.5

Maybell

iTrader: (2)

Nice lookn product Adrian!

..but I have a challenge for you! For 12th and WGT...

Please make us some small spurs for brushless that allow us to have a smooth diff...as smooth as with a Kimbrough gear that is...

Pretty Please!!!

trdsupra88

iTrader: (25)

I run stock on a very small track. The lap times are generally 7-9 seconds...

AdrianM

iTrader: (4)

Ask and ye shall recieve. This gear is machined from acytel, takes 12 diff balls, is WAY harder to strip than a Kimborough and is just as smooth.

Note that now they are black not white. They look like the black 48p gear below but 78T in 64p. DB5078 $7.99ea.



This is the 78T gear with a 60T pinion on the DB12RR. Don't know if you would ever need a 110mm roll out but its nice to know you could get it if you needed to...lol!

Maybell

iTrader: (2)

Awesome Adrian! I will be shooting some business your way! Thanks!

Rdog

iTrader: (83)

Has anyone tried running the itf chassis with the regular upper deck on carpet with rubber tires? If so was it good bad or same.

mikel33

iTrader: (2)

I've done that. I think its still pretty good, but I am not necessarily the best judge of things. I do think it runs better with the ITF top deck. I was running someone else's for a while because we couldn't get any. The ITF seem to be a bit of a tweak monster if you hit the boards too often (as I do). To try and find a compromise, I cut off the crossmember at the rear on a standard topdeck. It seems to run pretty well that way. I run 17.5 stock rubber and my times are competitive with the modified top deck. I don't think its quite as good as the ITF but its not too bad.

Scottmisfits

iTrader: (7)

Hey guys, what's the smallest spur I can run to still get a good gear mesh with 13.5 and or 19t motors?

mr crum

iTrader: (5)

well i run 48 pitch and the smallest kimbrough i can get without hitting the top plate is a 72 t 48 pitch

Scottmisfits

iTrader: (7)

Sorry, I'm running 64p. Unless you can give me an exact O.D. of that spur.

Josh Hohnstein

iTrader: (3)

100 is about as small as you will want to go

cleblanc

iTrader: (49)

sorry for asking again, but either i missed the answer or it was overlooked. what brand or rather part # 64 pitch spur you guys runnin? thanks

quietstorm76

iTrader: (12)

I agree. I'm running 100 now.