Community
Wiki Posts
Search

3800 ?

Thread Tools
 
Search this Thread
 
Old 03-20-2006, 03:50 PM
  #1  
Tech Initiate
Thread Starter
 
Join Date: Mar 2006
Posts: 47
Default 3800 ?

i got a new pack from promatch and i did a soft charge like they recommened and it only peaked at 400mah , so i discharged at 30 amp and after about 5 seconds 2 of the lights went out and the rest took about 5 min to go out , is there something wrong with the pack ?
benroc is offline  
Old 03-20-2006, 04:11 PM
  #2  
Tech Addict
 
TL_XXX-S_racer's Avatar
 
Join Date: Jun 2004
Location: Florida
Posts: 577
Default

Did you use the GFX to discharge the pack or did u use the 030 discharger? If you used the Integy 030, thats a discharger not an equalizer. I recomend the Tekin Battery Doctor 8.0, which works great. Try charging it again, having the correct charging settings so the battery peaks off at around 125-135 F. Equalize the pack and give it a regular charge. I got mine and charged them up, with no problem. Try charging them but keep an eye on the temp. I dont believe the pack is bad or something is wrong. Try contaction ProMatch as well. It could be as simple as a false charge. Overall those packs will be awsome for whatever use youre going to put them too. You will be amazed with the power and run time. I was 100% satisfied with the 3 packs i ordered, and great service from ProMatch.

Hope this helps,and good luck
Chris
TL_XXX-S_racer is offline  
Old 03-20-2006, 04:43 PM
  #3  
Tech Initiate
Thread Starter
 
Join Date: Mar 2006
Posts: 47
Default

no gfx charger but i have the duratrax ice , and the intgety dischsrge tray 30 amp , so discharge on the teken tray to equalize then charge again ?
benroc is offline  
Old 03-20-2006, 06:09 PM
  #4  
Tech Addict
 
TL_XXX-S_racer's Avatar
 
Join Date: Jun 2004
Location: Florida
Posts: 577
Default

try charging the pack again, just put it on the 030 discharger till the lights go out. Then see what it peaks at. Temperature, and mAh. Try contacting ProMatch though if it continues. The Tekin tray equalizes the cells to the same voltage which is good so each cells gets the same amount of charge. Compared to the 030 discharges at 30amps it doesnt cut off at a certain voltage. If you leave the pack in long enough it goes down to 0 volts (correct me if im wrong). What I also like to do is once youre done using the pack put it on the 030 discharger until the lights get very dim. Then take the pack out of the tray and then place it in an equalizer(Tekin 8.0).

Good luck
Chris
TL_XXX-S_racer is offline  
Old 03-20-2006, 11:20 PM
  #5  
Tech Initiate
 
Join Date: Feb 2005
Location: PA
Posts: 48
Default

Hi, I too just ordered batteries from Promatch, I have a ice charger. And Novak Smart tray. Should I buy Tekin Doc.
rc10bob is offline  
Old 03-20-2006, 11:46 PM
  #6  
Ike
Tech Master
iTrader: (8)
 
Ike's Avatar
 
Join Date: Jan 2004
Location: Milwaukee, WI
Posts: 1,228
Trader Rating: 8 (100%+)
Default

Originally Posted by rc10bob
Hi, I too just ordered batteries from Promatch, I have a ice charger. And Novak Smart tray. Should I buy Tekin Doc.
No, your smart tray is just as good if not better.
Ike is offline  
Old 03-21-2006, 01:16 AM
  #7  
Tech Master
iTrader: (1)
 
burbs's Avatar
 
Join Date: Feb 2004
Location: wisconsin
Posts: 1,152
Trader Rating: 1 (100%+)
Default

If this is a new pack this is normal.. It only took a 400 mah charge because it false peaked,, all new packs false peak.. They have to be trained to work together as a pack...

On any discharge tray one cell will go out before another.. some cells discharge at different rates.. i have never seen a pack in 18 years have all of the cells go out at one time.. Any tray will work well you just have to watch the volatge.. you dont want to over discharge the cell.. the tekin tray is very nice bacuse it cuts off at the lower voltage.. the 30 keeps going until its dead..

after a cell goes out just enscrew the post from the cell. do the same as each goes out.. the rsting volateg after it done should equalize it close...

i dont recomend using a discharge tray to do a fully charged pack tho.. if you do make sure the fan is hooked up.. you can smoske the rsistors, they get very very hot.. Ive seen this happen mutiple times..
burbs is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.