Motor Break-In
got a new reedy quad spec 19t, whats best way to break this in and how?
|
Originally Posted by neon
got a new reedy quad spec 19t, whats best way to break this in and how?
767's take abotu 5 minutes @2v well almost any Reedy brush...is 5 mintures at 2V So I hope that helps, -Shookiec <>< |
How long on 1v?
Can you get more out of the motor by breaking it inn difrently? |
Do silver can motors need a Break-In?
|
Every motor needs sufficient time for break in for maximum performance. Are you talking about the Reedy Ti edition? or Cobalt 2 ? Those are the only 2 silver can motors I know of.
|
sorry to hijack, but I meant Mabuchi motor silver cans, the ones that came with the Tamiya Mini M03. I dont even know if you can replace the brush on those
|
|
Originally Posted by natskiboy
Do silver can motors need a Break-In?
yes on my silver brushes on a set of BRAND NEW 1s, i put them in a run it a 1v for 10min |
Originally Posted by Alex_kipper
yes on my silver brushes on a set of BRAND NEW 1s, i put them in a run it a 1v for 10min
I run mine untill the brushes sit flush against the comm. It normally takes 30-50 hours at 5v |
OPPS, my bad :nod:
sorry guys :blush: |
All times are GMT -7. It is currently 04:16 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.