Robitronic Avid Touring Car
10-19-2010, 09:24 PM
#872
the origional avid suspension parts and drivetrain still transfer over to the avid v2!
hope this helps ya out
10-20-2010, 04:05 AM
#874
Jeff i am assuming that the hotbodies shocks are available at skmotion. Can you get them as a set or do you have to buy everything separately?
10-22-2010, 01:33 PM
#876
Hello Guys
Yes on the ETS Shasa use a lot of the new LP Parts. The LIPO Chassi was not ready, it was a little mistake on the preproduction sample, no hole for the Differential...
Shasa use the new steering system, the one piece swaybar holder and new axles on the rear side.
The car was very fast, to fast, too much grip... the problem was traction roll, we need the thicker swaybars and the hard suspension arms... shasa and i forget the parts at home.
I hope for a better result on the next ETS race with the new LIPO Chassisplate and motormount :-)
Best Regards,
Thomas Nagel
Yes on the ETS Shasa use a lot of the new LP Parts. The LIPO Chassi was not ready, it was a little mistake on the preproduction sample, no hole for the Differential...
Shasa use the new steering system, the one piece swaybar holder and new axles on the rear side.
The car was very fast, to fast, too much grip... the problem was traction roll, we need the thicker swaybars and the hard suspension arms... shasa and i forget the parts at home.
I hope for a better result on the next ETS race with the new LIPO Chassisplate and motormount :-)
Best Regards,
Thomas Nagel
10-22-2010, 04:22 PM
#877
Jeff will all the suspension components from a avid 1 fit on the 2? meaning arms,rear hubs, front spindles, c hubs?
10-22-2010, 08:16 PM
#879
Steven thanks for the reply.
11-07-2010, 09:09 PM
#881
Carpet racing has been good and bad for me this year so far. Local races have done great, but went to Halloween Classic at the Gate a few weeks ago wow stock tc was some tight racing all weekend had some hard luck in Quals. ended up getting 4th in the D main but learned alot about this car it has so much traction almost to much but we did get it going good in my main really liked it, was running great.
11-08-2010, 10:34 AM
#882
what set-up did you end up with? my first carpet race with the car was terrible haha the set-up that was given to me at the time definately sucked on my track . but then i had a pracice day to really figure things out and i came up with my most recent set-up on petitrc.com and things have been going really well.
11-09-2010, 07:57 PM
#884
what set-up did you end up with? my first carpet race with the car was terrible haha the set-up that was given to me at the time definately sucked on my track . but then i had a pracice day to really figure things out and i came up with my most recent set-up on petitrc.com and things have been going really well.
As for what I learned about the car, it responds well to small changes in setup and is consistent through out run does not seem to tweak out. It is a very well built strong car, I had some good crashes @ the Gate and did not break a part the whole weekend. After checking some other cars out I believe this car has a very smooth drive train I know alot has been said about the thrust balls. I am still using the stock ones and my diff is smooth as silk. In summary I love this car, its strong, easy to tune, and everyone should go out and buy one tonight you will not be dissapointed.