TLR 22-4 2.0 Race Kit Thread!
|
|||
#766
Tech Champion
iTrader: (515)
Just got back from an event where they had no dedicated 13.5 wheeler class and 3 of the top 5 cars in open 4 wheel had 13.5s including my 22-4 2.0....unfortunately Kyosho took the 1st & 2nd spots but 3-4-5 were 22-4 2.0s I think. I know 5th was for sure. I've never seen so many plain white bodies, including mine, on one track at the same time.
#767
Tech Regular
iTrader: (11)
Front pivot
Being that the front pivot is on back order I just had a little idea that I tried with mine that I want to share. This will definitely get you guys back up and running in no time. Take the 2.0 front brace and put it on the rear of the pivot. It's not a hard to do mod. If you are handy with a dremel you can do it. Just sand down the center of the pivot by the short screw so that the brace lines up with the hinge pins. Once that's complete mount the brace. Do not tighten too tight. Make sure that the arms are free. For the bumper cut a slot so that the bumper fits over the brace and secure it as normal. Finished product should look like the picture. For the front I use the 1.0 steel brace however the 2.0 brace also works as it should. Give it a try!
Last edited by Bonez595; 10-30-2016 at 01:51 PM.
#768
What's a good diff setup for 13.5 ? Tight technical track
#771
Can I run 22-4 2.0 front arms on my 1.0? And will the rear 2.0 hubs and cva just bolt in also?
#772
Dumb question (I don't own a 22-4 yet), but are there front captured hexes? From the manual, it looks like it's held in by the pin only, and I don't see an aftermarket part.
Rear it looks like there is an optional clamping aluminum hex. Sound about right?
Rear it looks like there is an optional clamping aluminum hex. Sound about right?
#773
Correct they are held in by a pin but they are a tight pin. No design flaw or need for an aftermarket part.
#775
Thanks guys, just bought a 22-4 2.0! Looking forward to building it and driving it. I bought the buggy in part because of the great work Casper and Frank do here on rctech, so thanks guys! Time to watch some TLR build videos...
Last edited by tsair; 10-31-2016 at 05:01 PM.
#776
Finally got my hands on front pivots...thanks Frank Root for all the updates as!
#778
Car is fun to drive...By far my favorite class to drive might even sell my 8th scale to get a mod 22-4.
I had servo issues all night while racing. When I got home found the servo wires severed. I run the SPEKTRUM S6240 servo. I think the servo is too short and the wire harness is causing the damage. What can I do?
I had servo issues all night while racing. When I got home found the servo wires severed. I run the SPEKTRUM S6240 servo. I think the servo is too short and the wire harness is causing the damage. What can I do?
#779
Car is fun to drive...By far my favorite class to drive might even sell my 8th scale to get a mod 22-4.
I had servo issues all night while racing. When I got home found the servo wires severed. I run the SPEKTRUM S6240 servo. I think the servo is too short and the wire harness is causing the damage. What can I do?
I had servo issues all night while racing. When I got home found the servo wires severed. I run the SPEKTRUM S6240 servo. I think the servo is too short and the wire harness is causing the damage. What can I do?
#780
Thanks