TLR 22-4 2.0 Race Kit Thread!
|
|||
#1111
Tech Regular
iTrader: (6)
In 1/10, the smaller the turn motor, the more power it makes (i.e. 6.5T > 7.5t). Most people run a 6.5t or 7.5t motor when running in Mod 4wd. If you are new to 1/10, I'd probably recommend the 7.5t motor which will be easier to drive while you are learning.
You will want to get a 2S Shorty lipo. Anywhere from 50c to 100c and 5000 mAh (give or take a few hundre mAh) is about right. Currently I'm running a 65C 5000 mAh ProMatch shorty. The 22-4 2.0 is made for a Shorty Lipo config.
I run the kit set-up on the 22-4 2.0 and its excellent. The only mod I did was to swap the rear arms (Left to Right and vice/versa) and mount the shocks in front of the tower. You will have to drill a hole on front of each arm once they are swapped to accomodate the sway bar mount.
You will want to get a 2S Shorty lipo. Anywhere from 50c to 100c and 5000 mAh (give or take a few hundre mAh) is about right. Currently I'm running a 65C 5000 mAh ProMatch shorty. The 22-4 2.0 is made for a Shorty Lipo config.
I run the kit set-up on the 22-4 2.0 and its excellent. The only mod I did was to swap the rear arms (Left to Right and vice/versa) and mount the shocks in front of the tower. You will have to drill a hole on front of each arm once they are swapped to accomodate the sway bar mount.
#1112
#1114
Tech Regular
iTrader: (6)
Our track here is hot Florida outdoor, bumpy, hard red clay with some dusting around. More of an 1/8 scale track I'd say.
I just want to put a good motor/esc combo in it that I'll enjoy. But it would be nice if it fit into a race class or two for when we officially race them. I just have zero knowledge of the 1/10 buggy motors.
I just want to put a good motor/esc combo in it that I'll enjoy. But it would be nice if it fit into a race class or two for when we officially race them. I just have zero knowledge of the 1/10 buggy motors.
#1115
Tech Master
iTrader: (46)
Joe, Im in Clearwater & race around florida.. I love my Hobbywing 120Amp V2.1 several of my friends run the newer V3 version, its a great speedo. If you are ever going to run the supercup I would get a 13.5t as that class dos well & the motor is fun but if you want more go with a 10.5 it should be plenty.. Hit me up anytime
#1117
#1118
Front pivot, front belt (dont run slipper too tight) and a set of arms, thats all u need to start with.
#1122
Tech Elite
iTrader: (43)
not the sun gear diff ...sorry but the gear pulley....not sure, what it's made of. But it's definetly not metal.
http://www.insidelinerc.com/wp-conte...Gear-Diffs.jpe
http://www.insidelinerc.com/wp-conte...Gear-Diffs.jpe