Team Associated B6 & B6D thread
|
|||
#5236
Tech Initiate
For anyone running losi 22 3.0 rear hubs/axle and dogbones, what camber link setting and ball stud spacing?
#5239
Tech Rookie
Gearing
Hey all,
I'm running an ecopower slingshot 17.5 motor in my B6D with a 31 pinion and 69 spur. Everyone at the track looked at me like I had 8 heads. I showed them the manual recommends this gearing. Saturday was the first time I ran this buggy. Am I insane or are others just out there? I should note they were all running different motors too (modified).
I'll be running it again tonight to check motor temps.
I'm running an ecopower slingshot 17.5 motor in my B6D with a 31 pinion and 69 spur. Everyone at the track looked at me like I had 8 heads. I showed them the manual recommends this gearing. Saturday was the first time I ran this buggy. Am I insane or are others just out there? I should note they were all running different motors too (modified).
I'll be running it again tonight to check motor temps.
#5241
With a 17.5 I am at 31-33/69 and with a 1S motor I am at 28-30/69. Each car is different for cooling also. I say you are pretty right on.
#5242
Gearing sounds close to me.
#5244
Hey all,
I'm running an ecopower slingshot 17.5 motor in my B6D with a 31 pinion and 69 spur. Everyone at the track looked at me like I had 8 heads. I showed them the manual recommends this gearing. Saturday was the first time I ran this buggy. Am I insane or are others just out there? I should note they were all running different motors too (modified).
I'll be running it again tonight to check motor temps.
I'm running an ecopower slingshot 17.5 motor in my B6D with a 31 pinion and 69 spur. Everyone at the track looked at me like I had 8 heads. I showed them the manual recommends this gearing. Saturday was the first time I ran this buggy. Am I insane or are others just out there? I should note they were all running different motors too (modified).
I'll be running it again tonight to check motor temps.
#5248
Tech Addict
iTrader: (13)
Just put the Yatabe reds on the front and the Yatabe greens on the rear. Man these springs are short! Are you guys going with longer spring cups or using the kit setup cups with these springs, the kit calls for 5mm offset cups in the front and 0mm cups in the rear. And just sitting the preload to touching the spring with no compression I get about a 15mm ride height. I did preload them to get me up to 17mm. I run on carpet with small to medium jumps, some flat landers and some have landing ramps...
#5249
Tech Master
iTrader: (49)
Just put the Yatabe reds on the front and the Yatabe greens on the rear. Man these springs are short! Are you guys going with longer spring cups or using the kit setup cups with these springs, the kit calls for 5mm offset cups in the front and 0mm cups in the rear. And just sitting the preload to touching the spring with no compression I get about a 15mm ride height. I did preload them to get me up to 17mm. I run on carpet with small to medium jumps, some flat landers and some have landing ramps...