Problem with steering servos.
#1
Problem with steering servos.
Ok so I have been working on rebuilding my truck after it went for an unplanned swim in a river. For about 30-40 minutes.
I have the truck to a point where it was time to test the servos. So I hooked every thing up and started testing. All my shift servos work good now. Tho they need there endpoints reset.
And both steering servos seam to work fine on there own. but when I hook them up together one goes all buggy on me.
Here is a vid of whats going on with it. Let me know what you guys think please.
https://youtu.be/mXFFvVIpoBU
I have the truck to a point where it was time to test the servos. So I hooked every thing up and started testing. All my shift servos work good now. Tho they need there endpoints reset.
And both steering servos seam to work fine on there own. but when I hook them up together one goes all buggy on me.
Here is a vid of whats going on with it. Let me know what you guys think please.
https://youtu.be/mXFFvVIpoBU
#2
No one?
Oh and they are powered of a Castle 10amp BEC set to 6.0 volts.
And everything worked fine before I tor the truck down to rebuild it. Not sure whats going on here. Really want to get it back up and running again soon tho!
Oh and they are powered of a Castle 10amp BEC set to 6.0 volts.
And everything worked fine before I tor the truck down to rebuild it. Not sure whats going on here. Really want to get it back up and running again soon tho!
#3
Problem found. BEC is bad.