Schumacher's new K2 4wd buggy ..!
|
|||
#46
Suspended
#48
#50
Updated first post with access and details .. .. Please PM with any pertinent or needed details etc and I will include them on the first post as this develops..
#51
Tech Regular
Did you expect him to shooting guns into the air &'saying yehaw to make it sound more exciting? He's a bloody good lad is Trish, dead friendly & helpful, even if you don't run a Schumacher. Bloody good driver to.
#55
Suspended
Looking good Schumacher, they went well at the weekend, some very nice features!
#56
Tech Addict
#57
Tech Regular
Good luck with that! I don't know about them ball studs look's just like Serpent's ball studs which I hear have binding and breaking issue's? Maybe that's why there are so many washers which i think is a lot to deal with. I will replace them with lunsfords ball studs and Schuie ball cups never an issue with this!
#58
Tech Master
iTrader: (15)
I've purchased B5 studs (8mm and 10mm) and cups in advance, not knowing that the K2 would have these new captured ends, but I like them. I'll be ready to swap them for the AE set if they end up binding. I am also going to stick with the B44 wheels, I'll pick up U4321 and drill the centres out to the axle diameter and then glue in the 0.5mm spacers. I'm looking forward to getting my build on. This will be my first Schumacher since my 2000 Team Cougar!
#60
Tech Regular
I've purchased B5 studs (8mm and 10mm) and cups in advance, not knowing that the K2 would have these new captured ends, but I like them. I'll be ready to swap them for the AE set if they end up binding. I am also going to stick with the B44 wheels, I'll pick up U4321 and drill the centres out to the axle diameter and then glue in the 0.5mm spacers. I'm looking forward to getting my build on. This will be my first Schumacher since my 2000 Team Cougar!