Tekno RC SCT410.3 Thread
|
|||
#2176
#2177
Go "Settings" then to "Internet" > "Advanced" > "Content Settings" then check the "Block Pop Ups" box. C'mon guys lol
#2181
Tech Adept
#2182
I have no ads or pop ups whatsoever. Don't use the mobile version. Scroll to the very bottom and click" View Full Site" and bookmark it.
#2184
I have been having trouble with my 3656 4700 and sct pro combo in my new 410.3. Esc cuts out after a few mins, restarts and runs for 30 seconds, then cuts out again. Tried all the typical troubleshooting below, conclusion is that the esc is overloaded somehow (with help from hobbywing tech support). I suspect I could have a weak esc, maybe components out of spec. I know others have tried this combo on this truck. If it is working well, what is your setup?
Tried:
Re-calibrated radio
LVC off
Multiple different batteries of different brands (high quality, high C and capacity that work fine in other vehicle)
Updated firmware
Unplugged sensor wire
Different radio system (completely different brand)
Put radio/steering servo direct to battery
Checked all connections
14t and 16t pinion
Hard wired switch
Confirmed no binding in drivetrain
Punch set to min, no drag brake, no timing
Temps all ok, except caps on esc get hot with 16t pinion.
Side note: tech support (Angelo) has been extremely fast responding, and great support in the tech support thread here on rctech (Slotmachine, lewis110).
Tried:
Re-calibrated radio
LVC off
Multiple different batteries of different brands (high quality, high C and capacity that work fine in other vehicle)
Updated firmware
Unplugged sensor wire
Different radio system (completely different brand)
Put radio/steering servo direct to battery
Checked all connections
14t and 16t pinion
Hard wired switch
Confirmed no binding in drivetrain
Punch set to min, no drag brake, no timing
Temps all ok, except caps on esc get hot with 16t pinion.
Side note: tech support (Angelo) has been extremely fast responding, and great support in the tech support thread here on rctech (Slotmachine, lewis110).
#2187
I can't find the sct410.3 to eb48.3SL conversion parts list. Does anyone have a link to it?
#2188
Tech Elite
iTrader: (33)
#2189
I've had my HW SCT Pro ESC for about 3 months, do I need to update the firmware?