lexusbest |
2021-11-11 01:35:15 |
(Wikipost) Yokomo YZ-2
Welcome to the YZ2 Wiki!
Features for the lastest specification YZ-2DTM3.1- Long specification for dirt Main chassis Inheriting the chassis cut of dirt specification, it is longer with the same wheelbase as CAL3.
- Aluminum front suspension mount.
- Z2-DTM2B F2 body.
- JConcepts ASTRO High Clearance 7inch Wing.
Features for the lastest specification YZ-2CAL3.1- Long specification main chassis for carpets. Long wheelbase that enables even higher speeds.
- Steel front suspension mount.
- Z2-DTMBL S2 Lightweight body.
- Z2-CAL2W LMR Wing.
Common features for the lastest specification YZ-2DTM3.1 / YZ-2CAL3.1- The conventional position and the position of the suspension arm pin 1 mm higher can be selected on the front and back of the front suspension mount.
- Bulkhead integrated side plate with increased rigidity.
- The kingpin position has been changed with the new steering hub carrier, the axle position has been lengthened by 1 mm, and a steering stopper has also been added.
- Battery holder that is easy to adjust according to the height of the battery.
- Separate the rear mount base and upper arm holder to increase the flex around the rear and improve traction.
- Z2-018-5 5-hole shock mounting specification Rear shock tower.
- S4-S1S 3.0mm shaft specification front shock.
- S4-S1M 3.0mm shaft specification rear short shock.
- S4-008R5B L5 / LD Rear suspension arm (Φ3.5 pin).
- Z2-01069 Rear universal shaft (69mm bone).
Setup Sheets can be found here
DT CA DTM parts comparison
YZ2T Tranny Conversion List
YOKZ2-300RFT
YOKZ2-302CT
YOKZ2-302T
YOKZ2-304T
YOKZ2-503I
YOKZ2-0023
CAL3 manual
DTM3 manual
|