Rckid19

iTrader: (12)

What gearing do you guys use for your t5m for 17.5. And give me like 3 pinions to tune with and 2 spur sizes. Just picked up a t5m and got a shuur speed 17.5 with the hobby wing justock esc and I don't know st gearing only buggy thanks

lbckevin

iTrader: (107)

I am running the same motor and speedo. I run 27 /76 and 35 degrees of timing. You can go up one tooth and down a tooth depending on the track.

Gigasipke

iTrader: (4)

All lined up ready for 1st Qual run. Mine is the Red and Yellow one. Loving the truck.

Rckid19

iTrader: (12)

Thanks im gonna be getting a 26,27,and28 also how do you like the esc I have never had one so just wondering but I own a shuur speed already that's in my b5m and it screams

sanderson373

What's the best pinion for the 7.5t in this t5m

Gigasipke

iTrader: (4)

Losi 19t pinion using 84t spur
http://www.amain.com/rc-cars/losi-48...los4119/p22071

rigor

iTrader: (44)

Spot on... 19/84 is good. I recently switched to Losi pinions and they are nice.

mhughesjr

iTrader: (7)

I'm running a 19/84 on my truck with an 8.5T and it is perfect for my track; however, my motor is getting really hot after 5-6 min of run. I really hate to regear, has anyone used the motor fans? If so do they work?

Micah123

iTrader: (1)

are you running boost.......how about your motor end bell timing being too high........pinion/spur mesh too tight.

ALIEN3T

iTrader: (2)

Got a shapeways 3d printed one for a buddy, no change but added fan, people at the track he races at are seeing around 20 degrees drop in temp. no other change.

sanderson373

I have been using the 81 spur it came with and have a 19t pinion on my 7.5t so since u are sayin run 19t for a 84t spur then i should be able to bump up to a 21 atleast on my 7.5t am i correct......this is hard for me to really change this because i have been fighting for tq and plus i won 2 races with it already im jus tryin to get a little bit more speed out of it

aeRayls

iTrader: (3)

The T5 comes with an 84. Typically with a 7.5 I run a 19. You are not correct on changing the gearing. Using a smaller spur gear is the same as a larger pinion. To get the same final drive ratio as 84/19 you have to have 81/18. With 48 pitch gears 3 teeth on the spur equals 1 tooth on the pinion.

mhughesjr

iTrader: (7)

No boost or timing, and the mesh is good.

h.lourenssen

i have bought a low profile savox sc-1251mg fot my t5m and it seems that is doesn't fit on the servo mount. The exit of the cable is blocking the blue aluminium brace. Has anyone else had this problem and found a solution? Or am i doing something wrong?

HBRob

iTrader: (61)

Think some people are cutting the stress boot off the of the wire, this should let you get the wire closer to the servo so you can mount. Also, some are dremeling the mount to give some more clearance.

http://www.rctech.net/forum/r-c-item...251-servo.html
http://www.rctech.net/forum/13515936-post7721.html