Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#7051
Tech Adept
Dont do it. I drilled the chassis hoping to lose some weight. It was not worth it. I drilled some holes around the servo, front to back in battery slot, and around the motor area. Alot of holes and only shed 10 grams. It didnt hurt rigidity, it just looks like hell for no reason.
The motor holes helped with temps though, alot.
I have a new chassis on order now.
With the aluminum topshaft, screw kit, and shorty I am at 1560.
The motor holes helped with temps though, alot.
I have a new chassis on order now.
With the aluminum topshaft, screw kit, and shorty I am at 1560.
#7052
#7053
#7054
Tech Adept
#7055
got the ok to buy a b 5 m kit thank you mom you rock
#7057
Tech Addict
iTrader: (3)
Attention to detail. Just because it's only 1/2 gram it all adds up. Shorten all your wires, 14 gauge motor wires, short servo, check your tire/wheel weight some are heavier than others, ditch the VTS clutch for the old V2 or a AVID/Schelle slipper, Lunsford makes some sweet front axles, MIP will have there aluminum pucks out soon, Amain makes a 2S pan car battery that has enough power for a stock heat. This should get you close to minimum.
#7058
Tech Elite
iTrader: (67)
#7059
Someone please post some good links for stainless kits ..
Shopping for ...
Shopping for ...
#7062
Tech Adept
Promatch Lipos are very good performing batteries.
#7063
Tech Adept
Promatch 90c 3500mah shorty packs are $44.99 too!
#7065