Team Associated RC10 B5m Mid-Motor Thread
|
|||
#1938
I love all this talk about weight. BTW the aluminum top shaft is already sold out, I missed out and went to try and order it this morning.
I raced the JBRL race out in IERC in the rookie class (first major race in 20yrs for me). I placed 3rd, my protek 3000mah pack was really starting to lack punch after the 5min mark of the 6min main. It's a well used pack and should prob just be used for practice now.
My car without added weight and battery comes in at 1342g which is nice, but I'd like to get it down near 1285g.
Here are the mods I have on my car to make this weight:
-Ti associated Turnbuckles
-Aluminum Screws throughout
-EVO Typo's front and back
-Aluminum Hex's on the rear
I raced the JBRL race out in IERC in the rookie class (first major race in 20yrs for me). I placed 3rd, my protek 3000mah pack was really starting to lack punch after the 5min mark of the 6min main. It's a well used pack and should prob just be used for practice now.
My car without added weight and battery comes in at 1342g which is nice, but I'd like to get it down near 1285g.
Here are the mods I have on my car to make this weight:
-Ti associated Turnbuckles
-Aluminum Screws throughout
-EVO Typo's front and back
-Aluminum Hex's on the rear
#1939
Anyone come across a defective bearing(5x10x4)when u assembled the front steering block? My right side feels like the bearing is notchy when I spin the axle compared to the other side. Checked and no loctite got on the bearing.
Thanks!
Thanks!
#1943
Anyone have the problem with the top oring of the shocks not staying in place and popping out the side causing leaks!!
#1945
Tech Addict
on the o rings on shock.. just use a little associated clear silicone grease on them and they will be fine.. make sure they are in the slot too.
#1949
BTW
Couple teammates are now using the shorty pack, mid performs much better with.