Jmuck69

iTrader: (14)

No need for aluminum. Cut the buttons flush with a dremel and then drill holes for 3mm screws and done.

Kalio

Hmm, interesting idea. That would save weight and money. I might try that. Thanks!

Eddie_E

Remove 1 mm from the front ackerman, battery forward, 1.4-3 shock piston w/32wt oil up front (or 1.7-2 with 35wt)up front and M4 electron fronts.

dirt42fan

iTrader: (154)

I just got a low profile Savox SC-1252mg servo and went to install it and noticed that the wire is right where the servo mount screws to the chassis.

Any recommendations for this? Or do I just mount it up and forget about it?

Thanks and Merry Christmas!!

Cridd

iTrader: (16)

I'm using the low pro from redshop on shapeways, light and work good.

1/4milecrazy

iTrader: (5)

I removed the rubber grommet from the wires and then ground off the corner of the servo mount with a Dremel. Never had a problem, I have done this on many 5 series vehicles for others who are running smaller servos.

man1ac

Just finished my build. Work flawlessly! Altough I have to admin, every bag seemed to be labelled wrong. The manual sag (e.g.) Bag G and it was H (always one letter ahead/behind). Just installed the electronics (Nosram HD, 8.5T Sonic M2) and damn, that thing is fast

But the most depressing part still ahead: Thinking of a good style/painting and trying to paint that
Anyone ideas of a style with neon green/gunmetal (and third color? white? silver? red? metallic blue?)?

dirtdog

iTrader: (21)

When all else fails- (And you suck at painting) The good old fade from one color to the next is a good resort.

tobamiester

iTrader: (360)

Oh lord no, the two color fade...no!!! Just do one color. Keep it simple!

JBR18

Ok what am I missing? B5m manual says use 5mm offset spring cup. The cups are marked 1-4 in the kit. No 5...

racer1812

iTrader: (31)

Those are just mold numbers. Use the 'middle' size cup. Both front and rear.

man1ac

Feels like you making fun of me
I am just a few months into the new hobby and not that kind of excercized in painting/designing that kind of stuff.

Thats why I dont want to mess up the new toy (SC5M)

Gpeters66

iTrader: (1)

This is what I did and it works great. That little of weight difference, in my opinion, would not even be noticeable. I is a lot tougher.

tc5 man

I ran a B5M wing on my DEX210 v2 just using the wing washers and body clip had a few flip overs and no cracks at all tough wing. Compared to the Proline wing i had that was heavyier in bigger / more downforce but it was much weaker.

JBR18

Thanks