Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
Tech Champion
iTrader: (45)
If you notice on Cav's setup sheets he had the outer ball stud marked as -1. I assume he is removing 1mm of material from the steering block.
Tech Regular
iTrader: (2)
I did see that.....looks like I will be removing material
Suspended
iTrader: (115)
Well....no racing for me this today.......another week gone by and no ball stud from AE.....now it went from I was supposed to "have it Thursday or Friday" to "there was a delay in shipping somewhere, sorry for the inconvience"
Just a little more than frustrated at this point, so I ordered a set of the TiN ones from another vendor so I can run my dang car.
Just a little more than frustrated at this point, so I ordered a set of the TiN ones from another vendor so I can run my dang car.
Tech Master
iTrader: (4)
Well....no racing for me this today.......another week gone by and no ball stud from AE.....now it went from I was supposed to "have it Thursday or Friday" to "there was a delay in shipping, sorry for the inconvience"
Just a little more than frustrated at this point, so I ordered a set of the TiN ones from another vendor so I can run my dang car.
Just a little more than frustrated at this point, so I ordered a set of the TiN ones from another vendor so I can run my dang car.
Suspended
iTrader: (115)
Out of the two hobby shops and the track here, nobody had the correct ballstud.
I would have thought AE would have stepped up and sent me what I needed in stead of having a pissed off customer....but I went through all the hoops and still have no part.
If I would have known all this, I would have just ordered one online to begin with.
It is what it is at this point....
I would have thought AE would have stepped up and sent me what I needed in stead of having a pissed off customer....but I went through all the hoops and still have no part.
If I would have known all this, I would have just ordered one online to begin with.
It is what it is at this point....
It's one ball stud, and everyone can use spares... I would've just bought some myself while waiting on AE...
Tech Master
Tech Master
iTrader: (14)
Only $5 per ball stud...sheesh. That's titanium prices.
I order the ft rear hubs in blue from a main
Suspended
iTrader: (115)
Tech Regular
iTrader: (26)
Stupid question here but getting mixed results... How are you guys setting your ride height? Are you dropping from 4/6 inches off table or are you just sitting on the table and settling the suspension?
Tech Master
iTrader: (2)
Drop and settle it
Tech Lord
iTrader: (52)
Ready for battle (minus tires, of course)