Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#4771
Tech Initiate
car was good managed to take TQ and the win in 2wd mod buggy . it was a hard fought race a lot of fun to say the least . here is the race video
http://youtu.be/FaaMNB8WLuI
http://youtu.be/FaaMNB8WLuI
#4772
Didn't see the photo of 30 kits. The question wasn't how much is the car, mines sitting on the sofa here next to me, I just finished installing the transponder. The question was what is the wager you are willing to make but sense you only have for left and no photo of the 30 I guess there's no proof.
Thought you said we will be short on supply ?
You lose.....
Believe me Bill
Were way ahead of the curve here in Tacompton
BRAAA !
Got 30 & all but gone the same day.
Took us a week and a half to sell that many b5r.
Left my baby at the track . After racing my Centro its final day will be starting my build.
#4773
Tech Rookie
Yes, yes, people got 30 blah blah blah
I won't get mine for a few more days, so where's all the pictures!? I'm dieing here!
I won't get mine for a few more days, so where's all the pictures!? I'm dieing here!
#4775
as siow as you guys go a 17.5 boosted would be good at that track
#4776
Tech Regular
iTrader: (27)
car was good managed to take TQ and the win in 2wd mod buggy . it was a hard fought race a lot of fun to say the least . here is the race video
http://youtu.be/FaaMNB8WLuI
http://youtu.be/FaaMNB8WLuI
#4777
Tech Regular
Riverside HP is in RC nomansland for a weird reason. Usually if Hesperia and Redlands don't have something, that one does. Very surprised the west Riverside Corona area doesn't have a track. I will run my RM until summer, then get a new MM kit for my birthday from the wife.
#4780
Tech Master
iTrader: (77)
So was the B5 rear motor. I looked at the B5M manual and it also suggests the 4mm trailing axle insert for the stock set-up. I switched to the 3mm trailing axle insert in my B5 rear motor and then I had more steering than I could deal with. So the first change I make to the B5M from the stock set-up will be to use the 3mm trailing axle inserts.
#4781
Track looks a bit busy. Hard to race with so many challenges. I wouldn't bother boosting a 17.5. Don't see any place boost would kick in.
Anyways congrats on the win. Definitely challenging.
Anyways congrats on the win. Definitely challenging.
#4782
Car has plenty of steering with the kit set up, if anything all I notice was forward traction felt a bit low.
Hearing Ae will.be releasing brass rear arm mounts .
Something to look for ...
Hearing Ae will.be releasing brass rear arm mounts .
Something to look for ...
Last edited by Wild Cherry; 03-02-2014 at 09:04 AM.
#4783
Tech Addict
iTrader: (4)
Posted this in the rear motor thread, but figured I would put it here too since its the same. I used a 12mm setscrew and m3 locknut to secure the front axle. Some guys have had issues with the screws backing out and the wheel coming off, this should take care of that. Make sure everything is clean with alcohol or brakecleaner and use red loctite on the screw. Let the Loctite dry and then wipe everything back down and install axle into the hub. Make sure no Loctite gets on the bearing!!!
Travis
Travis
#4784