ironzgti35

iTrader: (33)

It doesn't bind through the travel but the caps don't have any wiggle under tension. I may just find a longer screw and space it out a little further. Also noticed you can't get a wrench on the nut once mounted since the cap so close to the nut

nitro2be

iTrader: (1)

Just back nut off little so it can wiggle, and mount top 1st then bottom so u can get wrench on..I'm using a flanged nut so little easier and looks clean

tom2tone

iTrader: (99)

Just got my aluminum caps mounted and I see what you guys are talking about as well. They do seem to be angled on the top but doesn't affect anything. Look ok to you guys?

CaseyD

iTrader: (2)

That's how most shocks look. My rb6 looks just like that at all 4 corners. I'm sure under the stock ball cup they aren't perfectly straight either. Those look super clean though.

nitro2be

iTrader: (1)

oh yea i like. buggy looks $$$ now.

nitro2be

iTrader: (1)

Wait, I believe yours screws are backwards. Nut goes to outside. That's how my 1/8 buggy are.

ramctd

iTrader: (5)

You are correct, the mount screw is backwards. Probably makes no difference at all. Just will make it more of a pain to remove and replace shocks.

ISH

call me crazy but i think this looks cleaner. i hope amain gets these in stock soon.

egobrkr

iTrader: (29)

So to the guys using the B5 shock caps how have they been holding up? The are more accessible then the aluminium caps from hotbodies.

Yeti AS3

iTrader: (77)

B5 caps work great. They are about a mm or so shorter so just unscrew the eyelet to make up for it.

RENOV8R

Needs orange wheel nuts

ironzgti35

iTrader: (33)

Is that the Sworkz wing? Mine should be shipping out today but I'm thinking about trimming the wicker bill area down like a traditional wing, looks too boxy

trashedmaxx

iTrader: (10)

I thought about doing that myself with mine. But in my opinion the the wing is pretty flexible. So cutting the wicker down would make that worse. What I did was cut it about halfway then put a few reamed holes in the wicker bill.

RC*PHREAK

iTrader: (146)

The caps work great, just make sure to put a screw in the bleeder hole. I left it out thinking I'd run a vented bladder. I blew out both rear bladders.

nitro2be

iTrader: (1)

Yes,friend of mine trimmed about an inch off the front.looks nice.