Hot Bodies D413 1/10 4WD Buggy
#2822
Here is the A1 race from Sunday; myself in the green D413 and Mondrell Brown in the white D413. This was his first time driving the car, which he borrowed from another very generous racer for the day.
+ YouTube Video | |
#2823
Been there done that...just added the HB red springs front and back, so we'll see if that does the trick.
#2824
Tech Rookie
quick correction on an earlier post of mine, tekin gen2 5,5t does not fit in saddle config sans modifications
#2826
i also ran a 410 before this and i agree. LOADS more room for electronics in the 413. probably my biggest gripe with the 410 was lack of room for electronics.
#2827
Tech Regular
iTrader: (10)
Fjelltorsk, why don't you post more details or even better yet, a picture. That way we can see what is really going on. It might be that there is just an installation issue. I have used a gen2 motor in the past and it is just the same size as any other motor, even the motor tabs are pretty standard. So nothing out of the ordinary that would say that it won't fit.
#2828
Tech Elite
iTrader: (59)
Fjelltorsk, why don't you post more details or even better yet, a picture. That way we can see what is really going on. It might be that there is just an installation issue. I have used a gen2 motor in the past and it is just the same size as any other motor, even the motor tabs are pretty standard. So nothing out of the ordinary that would say that it won't fit.
#2829
D413 parts now bumped back to Mid June on Tower.
#2832
Team Tekin
iTrader: (18)
The Tekin Gen 2 Redline will not fit in saddle pack configuration..
The rear of the can hits the bell crank. Our motor is shorter then ROAR max specs so I would assume we aren't the only one that will not fit.
Some dremel work to the bell crank and a little on the top deck will get the motor to fit.
HB has been made aware of the situation and hopefully there is a change sooner then later in some of the parts so that all motors that are within ROAR specs fit the buggy.
The rear of the can hits the bell crank. Our motor is shorter then ROAR max specs so I would assume we aren't the only one that will not fit.
Some dremel work to the bell crank and a little on the top deck will get the motor to fit.
HB has been made aware of the situation and hopefully there is a change sooner then later in some of the parts so that all motors that are within ROAR specs fit the buggy.
#2834
Tech Rookie
My hobby store guy says you cant get any hpi parts since great planes bought them.
#2835
Tech Champion
iTrader: (12)
You can wait a few months to buy for full support, but your buddies are running the newest and your not