Custom t4 chassis:D
#16
Lol yeah, it kept poping off so I stuck it there to stop it lol
I thought about get in a shorty for the project, so I wouldn't have to cut the outside of the chassis, but I wouldn't get much run time cause this is just a basher so I need as much time as possible lol
I thought about get in a shorty for the project, so I wouldn't have to cut the outside of the chassis, but I wouldn't get much run time cause this is just a basher so I need as much time as possible lol
#18
#19
So shoe goo is the answer for faster times...hmmm
#21
Tech Master
iTrader: (50)
Dude what is your problem? What gives you the right to bash someone for trying something? For all you know he's a 12 yr old kid. Not everyone has solidworks, a 3d printer, or a cnc router at their disposal so give him a break for trying to do something productiive. Time better spent then trolling around bashing people
#22
Tech Elite
iTrader: (1)
Dude what is your problem? What gives you the right to bash someone for trying something? For all you know he's a 12 yr old kid. Not everyone has solidworks, a 3d printer, or a cnc router at their disposal so give him a break for trying to do something productiive. Time better spent then trolling around bashing people
#23
Tech Master
iTrader: (50)
I'm guessing he's another one who thinks shoe goo equals servo tape, which it does not. Unless of course you can't figure out how to use servo tape.
Why are you even doing this?
FYI that aluminum laid flat like that is going to do next to nothing to remove flex. I think that was a waste of time.
Why are you even doing this?
FYI that aluminum laid flat like that is going to do next to nothing to remove flex. I think that was a waste of time.