TLR 8IGHT E 3.0 THREAD
#1141
Thank ya sir!
#1143
Is there a page that lists the parts shared between the 2.0 and 3.0? I have a e 2.0 w a lot of parts but I'm selling it for a 3.0!not shire if I should keep these parts. Thanks guys
#1144
We never put together any list of this nature but you could take the parts list for both and compare them. The primary things that are the same would be diff parts.
#1145
#1146
#1147
thank you very much
#1148
I run your awesome dunford setup on my scte2.0
. Is there a end all be all set up for the 3.0 to start from? Also I'll be indoor clay med bite (lesiure hours) until summer then outdoor low bite loamy
. Is there a end all be all set up for the 3.0 to start from? Also I'll be indoor clay med bite (lesiure hours) until summer then outdoor low bite loamy
Last edited by sanny632; 12-27-2013 at 11:10 AM. Reason: Spell check
#1149
Tech Apprentice
My 2.0 e has a wrecked front end and I need new shocks and possibly a new shock tower. I was wondering if the front and rear shocks and shocktowers of the 3.0 are able to be fit on the 2.0?
#1150
Tech Regular
#1151
will the 2.0 aluminum servo saver arm fit on the 3.0e
#1153
What is the part number for the metal spur gear?
#1154
#1155
Thanks DTR!
One more quick question (just so I don't screw it up out of the box... LOL):
Can someone recommend starting pinion with a Tekin T8 2050kV motor?
I only race outside, and mostly on medium to large (not huge) sized tracks.
Thanks in advance.
One more quick question (just so I don't screw it up out of the box... LOL):
Can someone recommend starting pinion with a Tekin T8 2050kV motor?
I only race outside, and mostly on medium to large (not huge) sized tracks.
Thanks in advance.