This is gonna sound ridiculous but...
#1
This is gonna sound ridiculous but...
Would it be possible to jam a Castle 2028 in my E-Revo with a little modification?
#2
Bump!
#6
Lol, the problem besides space I can think of would be the 8mm shaft
#8
Going to need a emaxx dual motor mount (only use the upper mount, that may have the clearance needed still need custom mount holes most likely. That or make a custom mount plate that will accomidate. May need to run mod 1 gearing, ie get a mod 1 spur (nitro tmaxx maybe?)
PS a 1515 can shred the drive line, not sure even w/ the steel parts (ie all shafts center and axle) if it will hold up for more than a few minutes :P
PS a 1515 can shred the drive line, not sure even w/ the steel parts (ie all shafts center and axle) if it will hold up for more than a few minutes :P
#9
Nah, its a 8S max, I'd do two 3S in series.
Going to need a emaxx dual motor mount (only use the upper mount, that may have the clearance needed still need custom mount holes most likely. That or make a custom mount plate that will accomidate. May need to run mod 1 gearing, ie get a mod 1 spur (nitro tmaxx maybe?)
PS a 1515 can shred the drive line, not sure even w/ the steel parts (ie all shafts center and axle) if it will hold up for more than a few minutes :P
PS a 1515 can shred the drive line, not sure even w/ the steel parts (ie all shafts center and axle) if it will hold up for more than a few minutes :P