EZ-Run brushless motor bullet connector unsoldered itself?
#1
EZ-Run brushless motor bullet connector unsoldered itself?
I was running my truck practicing long jumps & the bullet connector unsoldered itself from the motor , I just noticed soldering it back on the connector looks almost burnt.
It doesn't make much sense to me how it came off because I run low enough gearing on my pinon (14) & high on my spur (90) it shouldn't overheat & I only run a 2s lipo.
Anyways here's a video.
http://s1210.photobucket.com/albums/...rent=00031.mp4
Should I just solder my wires directly to the solder points on the motor & add bullet connectors halfway from the ESC & Motor?
It doesn't make much sense to me how it came off because I run low enough gearing on my pinon (14) & high on my spur (90) it shouldn't overheat & I only run a 2s lipo.
Anyways here's a video.
http://s1210.photobucket.com/albums/...rent=00031.mp4
Should I just solder my wires directly to the solder points on the motor & add bullet connectors halfway from the ESC & Motor?
#4