Which motor for SC, Novak HV 4.5 or Novak 4.5 ballistic?
#2
The HV motors are the same as the Ballistic 550 motors except the Ballistic is totally rebuildable . I switched from an HV 4.5 too a Ballistic 550 4.5T and didnt see any increase in power or speed .
#3
Tech Champion
iTrader: (168)
I'm running the older HV4.5 in my Slash 4X4 and it works fine. One reason is that I snagged one with the original 1/8" shaft so I don't have to buy different pinions. I know the 1/8" shafts had a tendency to snap off when used in 1/8th scales and monster trucks but I've never heard anyone complain about a Velineon 1/8" shaft snapping off in a Slash 4X4 so I figure I should be OK.
#7
tekin is the onl one that you can run with out a sensor, i dont know about trinity , novak you have to.
if your going to built the losi i run a 4.5 balistic in mine with a 2 cell 5200 30-40 turnigy lipo, LRP Sphere TC spec ESC
if your going to built the losi i run a 4.5 balistic in mine with a 2 cell 5200 30-40 turnigy lipo, LRP Sphere TC spec ESC
#9
i think the fantom is trinity
http://www.amainhobbies.com/product_...-550-Motor-45T
http://www.amainhobbies.com/product_...tor-45T-5000Kv
http://www.amainhobbies.com/product_...Truck-Motor-65
http://www.amainhobbies.com/product_...less-Motor-45T
http://www.amainhobbies.com/product_...Truck-Motor-45
http://www.fantomracing.com/products.php?cat=26
http://www.amainhobbies.com/product_...-550-Motor-45T
http://www.amainhobbies.com/product_...tor-45T-5000Kv
http://www.amainhobbies.com/product_...Truck-Motor-65
http://www.amainhobbies.com/product_...less-Motor-45T
http://www.amainhobbies.com/product_...Truck-Motor-45
http://www.fantomracing.com/products.php?cat=26
#10
I have both the HV and Ballistic... Both are good, both are the same minus you can rebuild the Ballistic. Compared to the Speed Passion 4.5 V10 it's slow, but smoother. And the Fantom Fusions are also nice the only difference is it's a 3mm shaft vs. a 5mm shaft.
#11
Tech Champion
iTrader: (168)
You have to use a sensored motor with a Novak speed control but you do not have to have a sensored controller to run a high-KV Novak motor (like the HV4.5). I have run a Novak 8.5 (540 size, 5800KV) motor on a Castle Sidewinder (sensorless controller) and it ran good.
#13
I'm not sure if the havok is able to have the stator changed out to a different wind count like the ballistic is either.
#15
can I run a 4.5 on my stock traxxas ESC from my brushless slash? Also, can i use my current pinions? Sorry had to clarify