Hyper TT 4wd 1/10th Truggy Thread
#2161
I'm running a 540 sized (Tekin Redline) 6.5 and I'm pulling wheelies all over the place, it's plenty of motor.
Running at 12t pinion. I go back and forth between 11t and 12t.
Running at 12t pinion. I go back and forth between 11t and 12t.
#2163
I run the same combo on mine and its insane with the Tekin 6.5 and high torque TT2277 armature...I detuned it to keep the wheelies down.
#2164
T-Bone Racing
Has anyone tried the T-Bone racing front or rear bumper on their TT? I need a new front bumper and they are backordered everywhere. Wondering if this is a better alternative?
#2165
I relocated the battery further forward for more front bite and better weight bias...Its getting closer to what I would call ideal, and i will find out this week how it handles...
I was at 46% front weight and its now almost 49% front weight. Should help with that extra lap I need. Its so stuck to the track its not funny. I was going to put the saddle pack set-up in the car, but I put a battery across the rear of the car with the motor flipped around, and the weight bias stayed at 46%, so I went this route. Cross weight is still dead nuts at 50%, so that's not an issue. I just need more front bite.
I was at 46% front weight and its now almost 49% front weight. Should help with that extra lap I need. Its so stuck to the track its not funny. I was going to put the saddle pack set-up in the car, but I put a battery across the rear of the car with the motor flipped around, and the weight bias stayed at 46%, so I went this route. Cross weight is still dead nuts at 50%, so that's not an issue. I just need more front bite.
Last edited by Dragula426; 02-14-2011 at 07:14 PM.
#2166
If anyone is looking for a used one, I just listed mine for sale on here.
http://www.rctech.net/forum/r-c-item...-hyper-tt.html
http://www.rctech.net/forum/r-c-item...-hyper-tt.html
#2168
Are you guys just cutting one side off the battery box to lay the pack flat?
#2173
Tech Regular
Has anyone tried the tekno slash 17mm hub adapters?
http://www.amainhobbies.com/product_...er-Set-Slash-2
http://www.amainhobbies.com/product_...er-Set-Slash-2
#2174
Tech Elite
iTrader: (7)
What is a good brushless motor and ESC setup for this thing? My preferred brushed motor is about a 17-19 turn, what is comparable in a brushless motor? Would that be about a 4.5?
Combining different brand motor and ESC is new to me, I've seen the Tekin ESC a lot on here with Mamba motor.
Combining different brand motor and ESC is new to me, I've seen the Tekin ESC a lot on here with Mamba motor.
#2175
Has anyone tried the tekno slash 17mm hub adapters?
http://www.amainhobbies.com/product_...er-Set-Slash-2
http://www.amainhobbies.com/product_...er-Set-Slash-2