Project: BASHER! (HPI RS4 MT)
#16
what pinion do you have on it now?
I checked the gear ratio for it and it looks like for a 10 turn you should be using about a 20 tooth pinion.
no clue for the bl though..
I checked the gear ratio for it and it looks like for a 10 turn you should be using about a 20 tooth pinion.
no clue for the bl though..
#18
You will have to gear a brushless motor differently than its equivalent brushed motor.
#21
here is the gearing chart .... it doesnt go any lower than 12 turn.
http://www.hpiracing.com/graphics/instr/mt/mt-23.jpg
http://www.hpiracing.com/graphics/instr/mt/mt-23.jpg
#23
Well I got the BL installed and the chassis brace.
The truck is slower then what it was with the KR but the fact that I have no maintenence to do its worth it.
I have allot more plans for this truck but since I have another project I am about to start this is on hold. But its performing good enough for now so I'm still happy with it like this
The truck is slower then what it was with the KR but the fact that I have no maintenence to do its worth it.
I have allot more plans for this truck but since I have another project I am about to start this is on hold. But its performing good enough for now so I'm still happy with it like this
#26
Hey wicked, still got that Reedy KR? How much are you willing to let it go for? No money at the moment, but curious, I need a 10x2 for the X4...