Dose Voltage cap help with dead spots?
#1
Dose Voltage cap help with dead spots?
Salutations folks. Ive been having an issue where every so often my steering and throttle will go out for a couple seconds then come back in. several people have said that the bec on my havoc 3s isnt giving enough voltage to the receiver and i need a voltage cap. Dose this sound right, and has this happened to anyone else? im using the following.
Spektrum Dx2.0 w/ sr300 receiver
Novak Havoc 3s
Ballistic 8.5 sensored
ACE 1313 servo 175oz/tq and .13 transit speed
using hobby people 5000mah 35c 2cell lipos
The voltage cap im speaking of is the one that is made by spektrum and plugs into the receiver.
Spektrum Dx2.0 w/ sr300 receiver
Novak Havoc 3s
Ballistic 8.5 sensored
ACE 1313 servo 175oz/tq and .13 transit speed
using hobby people 5000mah 35c 2cell lipos
The voltage cap im speaking of is the one that is made by spektrum and plugs into the receiver.
#2
It helps.. not always the solution, but good possibility it will be.
Havoc's like to thermal also.
Havoc's like to thermal also.
#3
Tech Fanatic
iTrader: (5)
I am having the same problems with my RX8 and dx3s, I was about to post this same question. I am also loosing both power and steering, I found this
http://www.spektrumrc.com/Products/D...ProdID=SPM1600
I spoke with the people at tekin and they told me to get a capacitor that plugs into the receiver is that the one they are talking about?
http://www.spektrumrc.com/Products/D...ProdID=SPM1600
I spoke with the people at tekin and they told me to get a capacitor that plugs into the receiver is that the one they are talking about?
#4
YEP... I use that in my 4wd slash and my ve8
#7
mine diddnt start doing this until my last 3 times at the track,im not sure why