The "Show Off Your Off-Road Wiring" Thread
#51
Hyper 8
#52
Not pointing fingers at anyone here...but I noticed a few pics in here with 12ga wires connected through out the esc-motor setup and a tiny solder joint. This will create a bottle neck and may heat up enough to dis/conn the wire over time.
#55
Tech Master
iTrader: (41)
Hi all. I have been following the thread on the On-road side and have loved the looks of some of those rides. Now I have 2 RC's here for your enjoyment....or not. lol
First is a Hyper 8 Buggy Electrified with a HW 150A and 2000Kv motor Mount is from OKhobbies.
Attachment 581063
Attachment 581064
Attachment 581065
Second is a GT2 that I made my own Electric Motor plate that mounts to the Trans and the chassis to give it strength and a flex free motor mount. it's made of 1/8 aluminum. and I am using a Fantom 2 8.5T brushless with a Novak GTB. And I could not wait to get this on the track so that's what it's soo dirty. when I get it clean I can take more pics. and if someone wants a better shot of the motor plate just let me know and when I clean it I can take it apart more.
Attachment 581069
Attachment 581068
More pics in reply
First is a Hyper 8 Buggy Electrified with a HW 150A and 2000Kv motor Mount is from OKhobbies.
Attachment 581063
Attachment 581064
Attachment 581065
Second is a GT2 that I made my own Electric Motor plate that mounts to the Trans and the chassis to give it strength and a flex free motor mount. it's made of 1/8 aluminum. and I am using a Fantom 2 8.5T brushless with a Novak GTB. And I could not wait to get this on the track so that's what it's soo dirty. when I get it clean I can take more pics. and if someone wants a better shot of the motor plate just let me know and when I clean it I can take it apart more.
Attachment 581069
Attachment 581068
More pics in reply
Last edited by jdeadman; 05-19-2014 at 06:23 PM.
#58
Tech Master
iTrader: (36)
Nice work abailey! You've clearly been lurking in the onroad wiring thread! Great attention to detail here. I like the clipped wire ends, the shrink-wrapped receiver wire, the shorty sensor wire, and the blacked out receiver and servo wires. Again, great attention to detail!
#60
R/C Tech Elite Member
iTrader: (37)
Nice work abailey! You've clearly been lurking in the onroad wiring thread! Great attention to detail here. I like the clipped wire ends, the shrink-wrapped receiver wire, the shorty sensor wire, and the blacked out receiver and servo wires. Again, great attention to detail!