Durango DEX210 Thread
#6166
What are the dimensions of the diff circlip? Or if anyone has the fastenal part number for the spring steel clips it would be much appreciated.
thanks in advance
thanks in advance
#6172
#6173
Moderator
iTrader: (470)
Join Date: Nov 2009
Location: North Carolina by way of SoCal!
Posts: 4,785
Trader Rating: 470 (100%+)
#6175
How tight re you all running your diff? Never had a diff I had to tighten this much. Likes being tight I guess. I'm almost all the way.
How about slipper as well , minis almost locked down
How about slipper as well , minis almost locked down
#6176
We run the diff a bit tighter than the ae diff I was used to before, but it's not too much tighter. Which balls did you use?
#6177
Everything is stock. I ave a B fast pro diff kit on the way
#6178
How many people are running AE diffs in their 210? any feedback on it?
#6179
Tech Regular
iTrader: (20)
17.5 dex210 carpet.. New to me Buggy
I picked up a new to me 210.. I have limited spares and a stock spur.. I transfered my electronics from my old 22.. As I am a last minute larry.. I trying to set this up for tomorrows club race. I have a SP 17.5v3 and a viper VTX10 esc... Running carpet... Can I get the gearing close? Boosted non Boosted does not mater.. From what I read.. I pretty much dead in the water for gearing... Looks Like I need the Tresrey shaft to run aftermarket spurs.. or a AE 69t spur..
The buggy is set up MM3... I read its reverse motor direction... Do I have to change a ESC setting..
I know this is last minute... I was also trying to get my DEX410r set up at the same time...
Running high bite carpet, small track...
The buggy is set up MM3... I read its reverse motor direction... Do I have to change a ESC setting..
I know this is last minute... I was also trying to get my DEX410r set up at the same time...
Running high bite carpet, small track...
#6180
No matter MM3, MM4 or RM3, Rm4, none of them require you to run your motor in a reverse direction, that's the clever part of the 210 design
I picked up a new to me 210.. I have limited spares and a stock spur.. I transfered my electronics from my old 22.. As I am a last minute larry.. I trying to set this up for tomorrows club race. I have a SP 17.5v3 and a viper VTX10 esc... Running carpet... Can I get the gearing close? Boosted non Boosted does not mater.. From what I read.. I pretty much dead in the water for gearing... Looks Like I need the Tresrey shaft to run aftermarket spurs.. or a AE 69t spur..
The buggy is set up MM3... I read its reverse motor direction... Do I have to change a ESC setting..
I know this is last minute... I was also trying to get my DEX410r set up at the same time...
Running high bite carpet, small track...
The buggy is set up MM3... I read its reverse motor direction... Do I have to change a ESC setting..
I know this is last minute... I was also trying to get my DEX410r set up at the same time...
Running high bite carpet, small track...