Jmuck69

iTrader: (14)

I have the Orion VDS-1007 so it should be bullet proof.

nolimit208

iTrader: (8)

If the mounting plate hits that tab on the Tranny when and if i shim it I would just shave off some of that tab that sits above it if needed.

AmiSMB

If you get a 3degree toe 0 degree antisquat plate then you can shim it to the max 3 degree antisquat. I bought the RC Junky aluminium rear front brace version which comes with shims and it works fine as the RF brace is attached to the chassis and not the gearbox so does not alter its height only the hinge pins for antisquat.

retro_ryan

Fitted a New Savox 1258 servo and can't seem to achieve full lock either way, i've even have the EPA to 120% and still no joy. Is there a way to adjust the steering linkage?

Jmuck69

iTrader: (14)

Zero everything on your radio, EPA and trim. Make sure tie- rods are a match. The linkage from servo horn has a 2mm gap and servo horn is on straight and not cocked to one side or the other. The recheck.

TAMAK

iTrader: (29)

Also make sure your caster inserts are on the same direction. lol... Not very proud of my mistake.. lol

Jmuck69

iTrader: (14)

I did that one race day. Went from #2 position to zero without changing caster block. Could figure out why I had a horrible push! After the second quali, I had homer Simpson moment. I was embarrassed for myself.

goofy4d

iTrader: (3)

Anyone running in 17.5 no boost?

Jmuck69

iTrader: (14)

Did anyone notice all of the new goodies added to the 210 "option parts"? Steel and aluminum pinions gears, tapered big bore pistons, dual tapered pistons, vented slipper plates, aluminum CVD axles, aluminum steering plate & steel front axle. Oh me..oh my!

ajj

iTrader: (18)

Yes...

aloksatoor

iTrader: (43)

But seriously this has been the first car that I did not feel the need to upgrade anything!! That's awesome work by 'rango!! Doesn't mean I dint buy the tresrey shiny bits though

Jmuck69

iTrader: (14)

True. i have a few Tresrey bits. rear CF camber brace, aluminum hexes and CF steering plate are the must haves. That's it! I do want Durango pinions because mine are wearing out.

aloksatoor

iTrader: (43)

I got the rw pinions and spurs whisper quiet and no wear yet !! the pinions I only found in speedtech online though but worth it

Autocratic

iTrader: (26)

Selling my DEX210.

http://www.rctech.net/forum/r-c-item...l#post10617551

DBL15

iTrader: (8)

i noticed your now selling both durangoes mate what car you moving onto?