Hex Power Tool Tips Standard Sizes

idbdoug · 07-04-2009, 09:06 PM

Hello
Does anybody know where you can get hex power tool tips in Standard(english) sizes for a electric screwdriver with a 1/4 inch shank?
Thanks
idbdoug

glassdoctor · 07-04-2009, 10:20 PM

http://www.thsracing.com/

RB FIVE · 07-04-2009, 11:08 PM

mip speed tips.

Mack_Mechanic · 07-05-2009, 07:00 AM

Quote:

Originally Posted by RB FIVE

mip speed tips.

$15 bucks a piece!?!?!?!

Dave H · 07-05-2009, 07:32 AM

I’ve had good luck with these, nice sharp ground end. Available as a set or individually.

http://ofna.com/tool-bits.html

Think these are the same:

http://www.dynamiterc.com/Search/Def...20wrench%20set

http://www.dynamiterc.com/Search/Def...20tip%20dyn292

Believe both brands are widely available.

glassdoctor · 07-05-2009, 07:39 AM

The THS ones have worked great for me, and they are $15 for a set of 4 so why keep looking? That's about as cheap as buying generic bits from the hardware store

Duster_360 · 07-05-2009, 11:03 AM

My Ofnas rounded on me in about 5months use and started stripping heads. Was disappointed in them. I replaced them with a set of Eds tools. Those look like they'll last a while. They were expensive, the 4 allens, a flat bade and phillips tips were $39.

They appear to be same quailty as my Thorp (Mip) drivers that I've been using for years and haven't seen any change in how sharp they are.

devilchrist · 07-05-2009, 11:07 AM

eds racing tips.

http://edsracingproducts.com/categor...-Tool-Tips.htm

Duster_360 · 07-05-2009, 11:19 AM

I bought mine from his eBay store and found them cheaper that way.....

RB FIVE · 07-05-2009, 12:48 PM

Quote:

Originally Posted by Mack_Mechanic

$15 bucks a piece!?!?!?!

Yea but those are uber nice quality.

idbdoug · 07-05-2009, 03:46 PM

thanks for the info
idbdoug