R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Electric Off-Road

Thread Tools Search this Thread
Old 03-27-2009, 11:07 AM   #1
Tech Initiate
Join Date: Mar 2009
Posts: 37
Default gold plated connectors from speedo to motor

Hey guys quick question. I run 13.5 truck, if I was to put gold plated connectors from my speed control to motor so I can quickly swap out the motor with out too much trouble would I lose anything by not having it hardwired the way I currently have it setup? just curious if I would notice a performance loss. I would like to start experimenting with different motors and putting the gold plated connectors on the wire would make swapping in and out easier.

Let me know what you think

Goblin77 is offline   Reply With Quote
Old 03-27-2009, 11:14 AM   #2
Tech Master
JeromeK99's Avatar
Join Date: Jun 2008
Location: Loma Linda, CA - USA
Posts: 1,137
Trader Rating: 3 (100%+)

A good connector will probably be better than soldering and resoldering the same wires over and over again. Old reused solder joints have more resistance than a good connector.

Go for it!

JeromeK99 is offline   Reply With Quote

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

All times are GMT -7. It is currently 03:50 PM.

Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net

SEO by vBSEO 3.5.0