TP4800 in a B44 using Diggity Designs
11-12-2008, 02:34 AM
#1
TP4800 in a B44 using Diggity Designs
Hi all!!
Sorry if the topic is already open elsewhere but I have not enough time to read all!!
Well, I would like to know as well what is the value of the dimension (as shown hereafter) given by the Diggity trays.
I would like to know the distance from cell to cell.
I have worked on the rear slipper drive cup, and I think I can move the cells closer to the centre of the car. But I have to know the requested dimension to drill my chassis as well.
Many thanks in advance!
Sorry if the topic is already open elsewhere but I have not enough time to read all!!
Well, I would like to know as well what is the value of the dimension (as shown hereafter) given by the Diggity trays.
I would like to know the distance from cell to cell.
I have worked on the rear slipper drive cup, and I think I can move the cells closer to the centre of the car. But I have to know the requested dimension to drill my chassis as well.
Many thanks in advance!
11-12-2008, 08:25 AM
#2
I do not have the exact measurements but maybe this picture can help you out a bit.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
