ckaspar

iTrader: (1)

I have a Hyperion EOS 0606i DC charger. I am looking for a hard case ROAR approved battery that I can use in my RC10-T4.

I have looked everywhere and I only see other taps for the batteries. Either proprietary or just another plug.

Do I need to buy a converter for the battery, charger, etc? or what?

What are you other Hyperion users doing?

RBMike

I don't have any 2 cell hard packs but I do use Hyperion. You can get a hyperion 2 cell side tap(3 wires). Wire the red wire from the tap to the positive wire on the battery, wire the middle wire from the tap to the plug that goes in the balance port on the battery (you will need to get that plug from the battery mfg). Wire the last wire from the tap to the negative battery wire & you should be good to go.

ckaspar

iTrader: (1)

Thank you. Where can I get the "hyperion 2 cell side tap(3 wires)" Do I have to call Hyperion or is that something hobby stores sell?

d4man

iTrader: (5)

Does this help out any??

ckaspar

iTrader: (1)

Exactly what I was looking for

WobblyWheels

iTrader: (1)

You are the man!
Thanks, I needed one too!

Cain

iTrader: (294)

RC Lipos has these as well. Free shipping too. Go to this page:

http://www.rclipos.com/Balancers.htm

scroll down for:

HP-LBA10-CAR
EOS Output Harness for Balance Charging 2S Car Packs
such as ORION and TRAXPOWER

shake&bake

iTrader: (11)

Ive been out of the rc scene for too long...I have a hyperion charger...which adapter would work with a reedy lipo (2s)? thx!

Miller_Time

iTrader: (11)

See if you can determine what type of plug it has, look at the left side of the image on this page.

d4man

iTrader: (5)

WOOHOO!! Glad I could help!!