need help!!
#1
need help!!
been a while since i have ran electric off-road. i traded some parts for novak gtx esc. tried to install it so that i can center the servo before putting the servo into the car.
installed esc to channel 2 on my receiver, put servo on channel 1, and plug pt on channel 3. no motor attached. soldered charged battery to correct terminals turn the esc switch to the on position and i get nothing, my light on my pt doesn't come on. my servo doesn't turn. tried it on an m8 and a 3pk system
does a motor need to be attached to finish the power circuit? if anybody has an idea, please reply
installed esc to channel 2 on my receiver, put servo on channel 1, and plug pt on channel 3. no motor attached. soldered charged battery to correct terminals turn the esc switch to the on position and i get nothing, my light on my pt doesn't come on. my servo doesn't turn. tried it on an m8 and a 3pk system
does a motor need to be attached to finish the power circuit? if anybody has an idea, please reply
#2
TLRacing
iTrader: (25)
been a while since i have ran electric off-road. i traded some parts for novak gtx esc. tried to install it so that i can center the servo before putting the servo into the car.
installed esc to channel 2 on my receiver, put servo on channel 1, and plug pt on channel 3. no motor attached. soldered charged battery to correct terminals turn the esc switch to the on position and i get nothing, my light on my pt doesn't come on. my servo doesn't turn. tried it on an m8 and a 3pk system
does a motor need to be attached to finish the power circuit? if anybody has an idea, please reply
installed esc to channel 2 on my receiver, put servo on channel 1, and plug pt on channel 3. no motor attached. soldered charged battery to correct terminals turn the esc switch to the on position and i get nothing, my light on my pt doesn't come on. my servo doesn't turn. tried it on an m8 and a 3pk system
does a motor need to be attached to finish the power circuit? if anybody has an idea, please reply
#5
yep, all the prongs are facing away from the esc. the guy i got this from ran an m11 system and i was plugging it into a m8 system, so i figured that i would just be able to plug it right in.
the plug reads like this switch to receiver
red,blk blk,red,white
the plug reads like this switch to receiver
red,blk blk,red,white
#10
Incase his was switched around for some unknown reason, the plug should be wired, looking at it from the plug side of the speedo going from the back (motor wire side) to front, red,black= switch, then black, red then white for the receiver.
#12