Installing TC5 hop up Spool/Building TC5 DRIFTER
#1
Installing TC5 hop up Spool/Building TC5 DRIFTER
Need some advice on building a TC5 Spool kit (Hop up) it comes with 2 plastic parts that I am clueless how to install. Also, Building this TC5 for a drifter and shop guty told me to put this locked spool on the rear? any suggestions in general for building a drifter with this car and please answer these questions. Thank you
#2
Tech Fanatic
iTrader: (10)
Join Date: Apr 2006
Location: Sydney, Australia. St Ives RC Club.
Posts: 961
Trader Rating: 10 (100%+)
Hey redtide,
The little plastic u shaped bits are called pin cushions and they pop over the pins on the end of the cv dogbone. They protect the aluminium spool from being damaged by the cv's. A word of warning though, the AE pin cushions are pretty fragile so I suggest getting yourself a few extra bags of them.
Sorry, I don't know anything about drifting
Have you tried posting this thread in the electric onroad forum? This is the offroad forum and you may not get much advice over here.
Good luck. The TC5 is awesome.
The little plastic u shaped bits are called pin cushions and they pop over the pins on the end of the cv dogbone. They protect the aluminium spool from being damaged by the cv's. A word of warning though, the AE pin cushions are pretty fragile so I suggest getting yourself a few extra bags of them.
Sorry, I don't know anything about drifting
Have you tried posting this thread in the electric onroad forum? This is the offroad forum and you may not get much advice over here.
Good luck. The TC5 is awesome.