mamba max problem
#1
Tech Adept
Thread Starter
mamba max problem
can i get away with not having the on / off switch on my mamba max esc? the reason im asking is because the red wire is not soldered to the board, i took it to a model shop they tried but they said its not serviceable due to its location, so will i be ok just cutting the black cable off aswell and not using it?
im a bit annoyed because it was like this stright out of the box new never used, im hoping the on off switch is not really required so i do not have to have the hassle of sending it back, its been 2 months already since i started to build my car and iv still not run it yet
im a bit annoyed because it was like this stright out of the box new never used, im hoping the on off switch is not really required so i do not have to have the hassle of sending it back, its been 2 months already since i started to build my car and iv still not run it yet
Last edited by Apexs; 02-07-2007 at 11:02 AM.
#3
#4
Tech Adept
Thread Starter
nice one thanks, i knew i had seen a castlecreations support forum somewhere i was just about to look for it
#5
No problem man , I just like how everyone is helpful when needed. I am new so I figured I can throw some n00b help around LOL