best velcro or "hook & loop" to hold ESC?
I run a Mamba Max setup and the USB is on the long side of the ESC. This means that to tune it, i need to remove it each time so i can fit the USB cable into the port.
I used servo tape, as usual, but removing it proved to be scary as the stuff i use is pretty incredible, plus it's just damn wasteful and inconvenient to have to lift it every time. I tried velcro, the yellow package stuff. the adhesive side worked great, but the damn velcro itself posed a problem. The soft side was such a high profile that when attached to the harder side, it would make the esc wobble atop a mound of velcro. What can i use? Is there a nice low profile velcro that works for this application? I'd like the ESC to be able to be pretty secure yet removeable. |
|
''Ultra Velcro'' It's what I use, less than 3mm
assembeled. The hook side seem's nearly smooth and dosn't hold or plug up with fluff. It's Black colour is nice to. |
Originally Posted by straydog
''Ultra Velcro'' It's what I use, less than 3mm
assembeled. The hook side seem's nearly smooth and dosn't hold or plug up with fluff. It's Black colour is nice to. http://www.velcro.com/consumer/products_um.htm thanks for the info. |
I have been using industrial strength velcro brand for several years and have never lost a ESC or RX.Just clean the surfaces you will be sticking the tape side of the velcro to with isopropyl alcohol 1st.
|
''builthatch'' Yes Sir that's the stuff. Found it at
a local hardware chain, Home Depot. Was reasonable $ less than $20.00 for more than enuff to even share some. Seen the Ind' stuff wider, white! glue. The clear or black glue on the Ultra stick's great. I have @ 9 or 10 Elect' components held in micro's. The body and ESC & Rec' in a RS4-P3. Spectrum Rec' in EB4-S3. LST,help's hold 2nd batt 5cell hump on frt shock tower. T-Maxx batt help again. Anywere I put a personal transponder it only need's @ 1/4'' grip to stay! This stuff is so cool I bet you could hold Heat Sink's on with it! |
All times are GMT -7. It is currently 11:53 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.