MGM Compro 8012 / Feigao 8s Problem HELP!
08-30-2006, 04:31 PM
#1
MGM Compro 8012 / Feigao 8s Problem HELP!
I just received a used MGM Compro 8012 & Feigao 8s and I am having problems getting it going. I programmed the controller via the manual, with the leds responding accordingly the entire time.
The minute I connect the motor and try to run it, I get a quick rotation out of the motor and then it goes dead. Same thing happens in forward & reverse, whether it is connected to the truck or spinning freely. I know it is not binding at all as I can spin it freely at any given time. The motor leads seem to be connected to the controller correctly.
The manual stated that the motor would beep throughout programming, so I connected the motor and reprogrammed. Throughout the entire thing the leds once again responded, but I did not see any life from the motor.
Seeing that this is my first brushless system, I am completely lost. HELP!
The minute I connect the motor and try to run it, I get a quick rotation out of the motor and then it goes dead. Same thing happens in forward & reverse, whether it is connected to the truck or spinning freely. I know it is not binding at all as I can spin it freely at any given time. The motor leads seem to be connected to the controller correctly.
The manual stated that the motor would beep throughout programming, so I connected the motor and reprogrammed. Throughout the entire thing the leds once again responded, but I did not see any life from the motor.
Seeing that this is my first brushless system, I am completely lost. HELP!
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
