moto44

iTrader: (9)

Any setups out there for a indoor clay track?

joelm

iTrader: (122)

I just pick one up and any suggestions and build tips would be greatly appreciated.

Anthony.L

iTrader: (41)

It’s an XRAY, no build tips required. Build it per the manual and you will be all good.

Jeepnman83

Hi there everyone does anybody on here have an xt4 they are willing to sell?

Aceja75

sold sold sold







XT4 for sale. ROLLER

Only ran 8 batteries

No time to run

Comes with lundsford titanium

turn buckles

Two sets of tires clay primes

And positrons

Extra parts : original

turn buckles and extra set of lundsford titanium

turn buckles

5 front arms







And 3 rear arms

$400.00

Lower 48

Also have a 6.5 r1 motor

rotor Ron tuned extra $$ 80.00

jph98

Interested in buying one of these for some occasional racing, can someone confirm the wheelbase and track measurements please as I can't find them listed anywhere on the xray website.

Also there are many pictures about of these so please post pics of your ride. Interested to see what the shell looks like as the xray shots aren't great.

Thanks

rraden

iTrader: (259)

Need to give this thread a boost. What is a good starting point for gearing with a 10.5t motor? I've calculated around 16-17/81. Just need a sense check to make sure I'm close.

b1narych0ice

Noticed this on rcamerica today...

https://www.rcamerica.com/xray-xt4-2...c-truck-360201

Probably just an update to match 2020 XB4 specs

Tractagator

iTrader: (3)

Excellent. Can't wait.

sea1swk

Any Rumors about a Shortcourse Chassis for this?

jph98

Anyone got any links to setup sheets for high grip carpet? I'm running the kit setup and I think I need to go stiffer on springs and heavier on shock oil but interested to know what other run.

Also interested if theres a guide to xray spring rates as I find it's not clear what rate the kit springs are.

Thanks

HaulinBass

iTrader: (16)

So i know very little about racing electrics. Picked up an xt4 to run for an event. What turn or KV motor would be ideal for an 1/8th scale track? Is it better to run sct stuff (4pole 5mm shaft) or standard stuff. Also the gearing what would get me in the ballpark for say an 80-100 foot straight without burning the car down in the infield.
ill more than likely sell it all off after this race so not looking for the best of the best just dont want to show up with a useless setup

Cain

iTrader: (294)

out here with the ET410 guys it was common to see them running anywhere from 6.5T to 5.5T motor setups, higher mah battery packs. Talking to some, the Tekin "Pro2" motors I have heard work well. more torque but not as much as say the Pro4 that some have said are overkill.

HaulinBass

iTrader: (16)

well got an orca r32 and 5.5t setup.
what will the changes be for the .2 model and when will it be released? i see rcamerica has it listed,
anyone know where to score a front shock tower? I back ordered one from amain but would be nice to find one in stock currently

Milkdudd

iTrader: (13)

From at least what I can tell nobody has had this in stock yet. Has Xray confirmed what changes the .2 version will include?