R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Electric Off-Road

Thread Tools Search this Thread
Old 02-08-2006, 01:06 PM   #1
Tech Regular
Join Date: Jun 2004
Location: Torrance, CA
Posts: 492
Default Hyper 21 tuning help needed

i need help tuning a hyper 21 pull start. i have this motor installed on a hyper 7 pro buggy. i made sure the carb settings were set to factory spec's. i have run about 8 tanks of fuel through. i can start the motor. it idles fine. but when i give it throttle it dies. it wont even rev past mid range. i have got it to run at 3/4 throttle. but when i start to work the throttle, half to full throttle, it dies. i have tried turning the main adjustment in 1 to 2 turns and it does not help. the low speed needle seems fine.

i did tune my traxxas jato over a month ago. this truck starts in less than 5 minutes and just keeps going. i never have to touch it. this is why i tried a 1/8 buggy.
whats the secret ???????
baih is offline   Reply With Quote

Similar Threads
Thread Thread Starter Forum Replies Last Post
Hyper .21 tuning questions Nickmind Nitro Off-Road 3 07-11-2007 10:30 AM
rb c6 lsn tuning help needed chris52 Electric Off-Road 7 03-29-2007 06:34 AM
Engine Idling/Tuning Help Needed dirtracer1 Electric Off-Road 7 09-17-2006 06:35 PM
tuning advice needed downunder23 Electric Off-Road 0 03-19-2006 10:06 PM
Motor Tuning expert needed TAW Onroad Nitro Engine Zone 6 06-16-2004 12:34 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

All times are GMT -7. It is currently 08:54 PM.

Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net

SEO by vBSEO 3.5.0