Hyper 21 tuning help needed
i need help tuning a hyper 21 pull start. i have this motor installed on a hyper 7 pro buggy. i made sure the carb settings were set to factory spec's. i have run about 8 tanks of fuel through. i can start the motor. it idles fine. but when i give it throttle it dies. it wont even rev past mid range. i have got it to run at 3/4 throttle. but when i start to work the throttle, half to full throttle, it dies. i have tried turning the main adjustment in 1 to 2 turns and it does not help. the low speed needle seems fine.
i did tune my traxxas jato over a month ago. this truck starts in less than 5 minutes and just keeps going. i never have to touch it. this is why i tried a 1/8 buggy. whats the secret ??????? thanks |
All times are GMT -7. It is currently 08:52 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.