M_Chambers:1/8

iTrader: (2)

I have a 1/8 exceed Madtorque (motor on axle setup) and I'm not sure what esc to get......I have 2 20t brushed motors in it. I need a decent speed controller that will hold up to some serious resistance from the motors because I have a snow plow and 2 decent sized trailers I haul my 1/10 sct on. It doesn't matter waterproof or not but here is the catch......I'm on about a $50 budget what should I get?

stanmondz

iTrader: (20)

dont know what the turn limit is,but look at the rc4wd dual motor outcry esc

OSRC

iTrader: (10)

Assuming the motors are wired in parallel, anything that can handle 10 turns and up should do it.