Built RTR Axial Wraith
01-05-2014, 11:40 PM
#1
Built RTR Axial Wraith
I think its time to let go the wraith, it just does not get used and I keep spending money on it..... 
It is hardly used and come with whole lots of goodies.
* Kit form, so it comes with front Uni shaft instead of dogbone.
* Tekin Pro 4 3300 KV (I think 1 pack old) comes with Box;
* Castle MMP and BEC (set at 7.4V);
* RC4WD 2 Speed Tranny with shift servo;
* Hitec HS-7954 Servo (29kgcm @7.4V) waterproofed with Alloy horn;
* Full Titanium Vp suspension links (upper and lower) as well as draglink and tie rod;
* RC4WD Raceline Monster beadlock wheel with scale hardware and Gmade Hub, fitted with RC4WD Baja Claw Tyre, plenty of thread left;
* Futaba 3PL Tx and Rx, shift on the fly;
* Gmade Piggy-backed shock all round;
* MIP Drive shaft;
* Vp upper link mount and Axial HD bevel gear (standard ratio);
* Alloy Hopup - Shock hoop, Chub, Knuckle, Lockout, Servo mount, Lower link mounts;
* LED light and Driver Figure;
* Turnigy 4500 mah 3s Lipo (maybe excluded if need to be posted);
* Stock tyre fitted with Alloy Rim;
It is fully RTR and stupidly fast, more than $1500 spent on it and most of the part is still like brand new...
Cost:SOLD ono plus post. I am in Perth (6065) and buyer will determine the post service (and insurance) to be used and pay for it.
It is hardly used and come with whole lots of goodies.
* Kit form, so it comes with front Uni shaft instead of dogbone.
* Tekin Pro 4 3300 KV (I think 1 pack old) comes with Box;
* Castle MMP and BEC (set at 7.4V);
* RC4WD 2 Speed Tranny with shift servo;
* Hitec HS-7954 Servo (29kgcm @7.4V) waterproofed with Alloy horn;
* Full Titanium Vp suspension links (upper and lower) as well as draglink and tie rod;
* RC4WD Raceline Monster beadlock wheel with scale hardware and Gmade Hub, fitted with RC4WD Baja Claw Tyre, plenty of thread left;
* Futaba 3PL Tx and Rx, shift on the fly;
* Gmade Piggy-backed shock all round;
* MIP Drive shaft;
* Vp upper link mount and Axial HD bevel gear (standard ratio);
* Alloy Hopup - Shock hoop, Chub, Knuckle, Lockout, Servo mount, Lower link mounts;
* LED light and Driver Figure;
* Turnigy 4500 mah 3s Lipo (maybe excluded if need to be posted);
* Stock tyre fitted with Alloy Rim;
It is fully RTR and stupidly fast, more than $1500 spent on it and most of the part is still like brand new...
Cost:SOLD ono plus post. I am in Perth (6065) and buyer will determine the post service (and insurance) to be used and pay for it.
Last edited by colgout; 02-05-2014 at 08:30 AM.
01-09-2014, 03:52 PM
#2
Bump....
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
