Programmable servo. Can this be done?
#1
Tech Addict
Thread Starter
Programmable servo. Can this be done?
I have a unique situation. I have an XTM X-factor, and I am setting it up for 4 wheel steering. I am wondering if the servo programmer is capable of the following.
I need the rear servo to:
1> turn the opposite direction than the front servo. (connected with y-harness)
2> hold neutral position until approx 75% of steering travel is given.
3> turn to a maximum of 50% servo travel when 100% wheel travel is given. (from 75% to 100% wheel travel, servo will move from 0 to 50%)
Is any of this possible?
I need the rear servo to:
1> turn the opposite direction than the front servo. (connected with y-harness)
2> hold neutral position until approx 75% of steering travel is given.
3> turn to a maximum of 50% servo travel when 100% wheel travel is given. (from 75% to 100% wheel travel, servo will move from 0 to 50%)
Is any of this possible?
#2
I have a unique situation. I have an XTM X-factor, and I am setting it up for 4 wheel steering. I am wondering if the servo programmer is capable of the following.
I need the rear servo to:
1> turn the opposite direction than the front servo. (connected with y-harness)
2> hold neutral position until approx 75% of steering travel is given.
3> turn to a maximum of 50% servo travel when 100% wheel travel is given. (from 75% to 100% wheel travel, servo will move from 0 to 50%)
Is any of this possible?
I need the rear servo to:
1> turn the opposite direction than the front servo. (connected with y-harness)
2> hold neutral position until approx 75% of steering travel is given.
3> turn to a maximum of 50% servo travel when 100% wheel travel is given. (from 75% to 100% wheel travel, servo will move from 0 to 50%)
Is any of this possible?
#3
Tech Addict
Thread Starter
thank you.