[Randy Caster]

Ok, it's taken a few days, but I'm about to tear my car down and try a completely different setup, so before I do I'll post the setup from Bending Cornerz that a few people have been asking for.

The track is a small tight outdoor asphalt track, medium grip.

FRONT
Upper Arm Position: 3
Upper Arm Spacer: 2mm
Damper Position: 2
Lower Arm Position: 1
Sus. Mount Spacer: F=.5mm R=1mm
Camber: 1.5*
Ride Height: 5.4mm
Rebound: 100%
Front Drive: Spool
Stabilizer: 1.5mm
Wheel Hex: 4mm
Wheel Spacer: .5mm
Piston: 3 Hole
Oil: 550
Spring: HPI Pink
Front Pulley: 36 Tooth

REAR
Upper Arm Position: 1
Upper Arm Spacer: 2mm
Upper Arm Spacer On Hub: 2mm
Damper Position: 5
Lower Arm Position: 2
Sus. Mount Spacer: F=0 R=0
Camber: 1*
Ride Height: 5.6mm
Rebound: 100%
Stabilizer: 1.4mm
Wheel Hex: 4mm
Wheel Spacer: .5mm
Piston: 3 Hole
Oil: 550
Spring: HPI Blue

GENERAL
Front Toe Angle: 0*
Front Sus. Mount F=C R=C
Rear Sus. Mount F=XA R=D
Upright Spacer: .5mm
Steering Spacer: 4mm
Rear Hub Spacer: .5mm
Center Pulley: Direct
Front Sus. Arm Spacer: 2.5mm
Rear Sus. Arm Spacer: 3mm
Lower Deck: 2.25mm
Body: Protoform Mazda 6 LW, 6mm Forward
Tire: Sorex 36R

I believe this is all off of the original Tamiya setup sheet, I downloaded it off of Ed's website.

Ed - Feel free to post this setup on your site if you'd like.